MF 6S 180
Make: Massey Ferguson
Model: MF 6S 180
Hydraulic System: Load Sensing Closed Center System
Maximum Pressure: 2900 PSI
Maximum Flow: 29 GPM
Massey Ferguson offers optional hydraulic systems for different editions. Use Standard LS Closed Center remotes if possible. Please check with your tractor dealer or manual for proper system type and instructions.
Essential : Open Center 29GPM (110 l/min)
Efficient — Exclusive : LS Closed Center Dyna‑6 = 39.6 GPM (150 l/min) or Dyna-VT 50 GPM (190 l/min)
Pump Model: FMC-650-HYD
Pump Model: FMC-200-HYD-210/304
Port Sizes: 2" X 1-1/2"
Max Flow: 200 GPM
Maximum Shutoff Pressure: 80 (210) / 120 (304) PSI
Pump Model: FMC-HYD-210
Pump Model: FMC-150-HYD-206
Installation Instructions for Load Sensing Closed Center System
1. Install flow limiter in motor inlet. (suggested)
2. Shut off sprayer boom and agitation valves. Install pressure gauge between pump and shut off valve.
3. Close motor needle valve; loosen jam nut, screw needle valve clockwise until seated, and lock nut.
4. Adjust tractor flow control to minimum flow setting (turtle).
5. Move hydraulic lever to "Lower/Retract" position to start pump.
6. Adjust tractor flow control until sprayer shut-off pressure is below maximum shown in table.
If the flow limiter stops oil flow to the motor:
6a) Move hydraulic lever to "Float" or "Neutral" to remove oil pressure from the flow limiter.
6b) Adjust tractor flow control to a lower flow position.
6c) Repeat steps 5 and 6.
7. Open the sprayer agitation valve to get desired spraying pressure.