TM175
Make: New Holland
Model: TM175
Hydraulic System: Load Sensing Closed Center System
Maximum Pressure: 2750 PSI
Maximum Flow: 31.8 GPM
On certain Case and New Holland tractors a 710362010 MANUAL DENTENT KIT must be obtained from your Case/New Holland dealer to operate a hydraulic driven pump. This kit converts from a 4 position detent kick-out to a 4 position with detents in all positions. This valve will not return to neutral under pressure over 2000 psi (137.9 bar).
Pump Model: FMC-HYD-204
Pump Model: FMC-HYD-210
Pump Model: FMC-150-HYD-206
Pump Model: FMC-650-HYD
Pump Model: FMC-200-HYD-210/304
Port Sizes: 2" X 1-1/2"
Max Flow: 200 GPM
Maximum Shutoff Pressure: 80 (210) / 120 (304) PSI
Installation Instructions for Load Sensing Closed Center System
1. Install flow limiter in motor inlet. (suggested)
2. Shut off sprayer boom and agitation valves. Install pressure gauge between pump and shut off valve.
3. Close motor needle valve; loosen jam nut, screw needle valve clockwise until seated, and lock nut.
4. Adjust tractor flow control to minimum flow setting (turtle).
5. Move hydraulic lever to "Lower/Retract" position to start pump.
6. Adjust tractor flow control until sprayer shut-off pressure is below maximum shown in table.
If the flow limiter stops oil flow to the motor:
6a) Move hydraulic lever to "Float" or "Neutral" to remove oil pressure from the flow limiter.
6b) Adjust tractor flow control to a lower flow position.
6c) Repeat steps 5 and 6.
7. Open the sprayer agitation valve to get desired spraying pressure.